Instructions Before Installation; Installing Mini Heki Plus - Dometic Mini Heki Plus Installation And Operating Manual

Mini Heki Plus
6

Instructions before installation

➤ Before installation, check the roof thickness of your vehicle. Consult the
vehicle manufacturer if you have any questions.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts),
cables and cabinets in the vehicle interior must not be damaged when
sawing the hole.
– Only fit the roof light on flat and parallel interior and exterior roof areas
with a maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
6.1 Pressing out the hole
See fig. 2
6.2 Using the reinforcing rails
Supplementary to fig. 3
➤ Before installation, check whether the roof hole needs reinforcing.
➤ Remove the foam according to the width of your reinforcing rail (not in
scope of delivery) (A).
➤ Fit the reinforcing rails (B).
7

Installing Mini Heki Plus

Supplementary to fig. 4
The scope of delivery contains a mounting frame, which is suitable for roof
thicknesses of 25–42 mm or 43–60 mm.
➤ Measure your roof thickness W.
➤ Shorten the sleeves to size H (see table).
➤ Use the screws with appropriate lengths (see table).
Siehe fig. 5
➤ Check that the roof light has sufficient space around (approx. 1 to 2 mm)
it in the roof opening.
EN
Instructions before installation
13