Samsung NX58H9500W Series Installation Manual page 26

Installation instructions
*approximately
21/32" (16.5 mm)
Screw must enter
wood or concrete
NOTE
To install the Anti-Tip bracket, release the leveling leg. A minimum clearance of
21/32" (16.5 mm) is required between the range bottom and the kitchen floor.
To check if the bracket is installed and engaged properly, remove the warming
drawer or storage drawer and look underneath the range to see that the leveling
leg is engaged in the bracket. Carefully tip the range forward. The bracket should
stop the range within 4" (10.2 cm) of tipping. If it does not, the bracket must be
reinstalled.
If the range is pulled from the wall for any reason, always repeat this procedure
to verify the range is properly secured by the anti-tip bracket. Never completely
remove the leveling legs or the range will not be secured to the anti-tip device
properly.
26 English
Anti-Tip
bracket
Step 5. Plug in and place
WARNING
BEFORE OPERATING OR TESTING, follow the grounding requirements on pages
20 ~ 21 in this manual. Improper connection of the grounding plug can result in a
risk of electric shock.
• All gas ranges come with a power cord. The power cord is connected to the
rear of the range. Please review Electrical requirements on pages 20 ~ 21.
• All U.S. and Canadian models are produced with a 3-wire, 120-volt, 60-Hertz
electrical system. The entire system, including the power cord, is preinstalled
and prewired at the factory. Altering any part of this system may result in a
short or overload.
Gas Range Plug
1. Plug in the power cord. Make sure the
outlet meets local or national electrical
codes as referenced on pages 20 ~ 21.
2. Slide the range into place.
3. Check the gas supply line to make sure
it did not get damaged and it stayed
connected during positioning.
4. Check to make sure the back leg of the
range has slid into the anti-tip bracket.
Carefully tip the range forward to
ensure that the anti-tip bracket engages
the back brace and prevents tip-over.