Backrest; Headrests - Sunrise Medical Krypton F Directions For Use Manual

6.6 Backrest

To adjust the back angle, please undo the Allen screw (1) and
remove it. Set to the desired position and then refit the Allen
screw in this position, and tighten to the specified torque. (Fig.
6.6.1).
Folding backrest
To make it easier to transport the wheelchair, the top half of the
backrest can folded down.
To do this, press both levers (1) and fold the backrest down.
When folding the backrest back up, please make sure that both
sides are firmly interlocked (Fig. 6.6.2 to Fig. 6.6.3).
WARNING!
• Risk of Injury: Be careful not to trap your fingers in the folding
mechanism.
Adjustable Back Sling
The adjustable back sling can be adjusted for tension by using
several straps, (Fig. 6.6.4).
Height-adjustable backrest
The backrest may be set to various back heights, in 25 mm
steps (4 adjustment ranges: 250-300 mm, 300-400 mm,
400-450 mm and 450-475 mm).
Remove the side cushions of the upholstery, and if necessary,
the belt at the back, which covers the screws.
Release the screw (1) and set the backrest to the desired
height. Then tighten the screws again (Fig. 6.6.5).
See the page on torque.
CAUTION!
Please take into account the altered centre of gravity when
setting the angle of the backrest.

6.7 Headrests

The headrest (Fig. 6.7.1) can be raised and moved horizontally
both forwards and backwards.
To do this, loosen the screw (1, 2 or 3).
Now you can adjust to the desired position. Tighten screws
again (see the page on torque).
Krypton F
Fig. 6.6.1
1
Fig. 6.6.2
Fig. 6.6.3
Fig. 6.6.4
Fig. 6.6.5
Fig. 6.7.1
23
1
1
1
2
3
Rev.1.0