Electrolux SG231N User Manual page 16

16 www.electrolux.com
4. Remove the door.
5. Unscrew the upper pin and screw it
on the opposite side.
6. Refit the door. Make sure the edge of
the door is parallel with the edge of
the top.
7. Unscrew the pin (A) and screw it on
the opposite side.
8. Remove the cap (B) and position it on
the opposite side.
9. Screw the lower hinges.
10. Refit the plinth.
11. Stand the appliance upright.
12. Fit the handle on the opposite side
and put the plastic caps (contained in
the instructions bag) in the free holes
2
1
A
B
CAUTION!
Reposition, level the
appliance, wait for at least
four hours and then connect
it to the power socket.
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal
adheres to the cabinet.
• The door opens and
closes correctly.
If the ambient temperature is
cold (i.e. in Winter), the
gasket may not fit perfectly to
the cabinet. In that case, wait
for the natural fitting of the
gasket.
In case you do not want to
carry out the above
mentioned operations,
contact the nearest
Authorised Service Centre.
The Authorised Service
specialist will carry out the
reversibility of the doors at
your cost.