Craftsman 706.813380 Operator's Manual page 5

LOCKING AND UNLOCKING THE UNiT
Locking the Unit:
o Putt handle lever out.
Insert the key into the lock and turn it clockwise.
Release lever.
o If the drawers do not open, push att the drawers
completely closed to release the tockbars
/
/
Handle Lever
Figure 15
Unmocking the Unit:
Always check the unit to make sure all the drawers are
completely closed before locking.
o Putt the handle lever.
o Insert key into the lock and turn it counterclockwise.
* Release lever.
SELF CLOSING SLIDES
The self closing feature will putt the drawer closed when
the drawer is pushed past the slide detent. This is located
approximately 1/2" from the fully closed position.
REMOVING AND iNSTALLiNG SLIDES
Slide Removal =
The drawers in these units can be rearranged to fit your
specific needs. This means that drawers may be moved
or replaced as desired. For example, a 6qnch drawer
may be replaced by a 2=inch and a 4=inch drawer, or
three 24nch drawers.
o First remove the drawer (Refer to Operation A).
o Lift and hold the spring retainer, and push the slide
toward the rear of the unit.
The slide may now be removed.
Figure 16 _ Spring Retainer
Slide Installation =
o Place the slide in the appropriate position in the unit and
pull toward the front of the unit until the spring retainer
snaps into position and secures the slide.
o For smooth operation, make sure that the drawers are
matched with their original slides.
[@ = mO@ kt_
LOC K SYSTEM
Problem
The unit
unlocks
but the
drawers
still wilt not
open.
The unit
locks but
some
drawers
still are not
locked.
Cause
One or more
of the drawers
are holding the
tockbars from
releasing.
The cover on
the chest is
holding the
tockbars from
releasing.
The release
cabtes are not
working.
The unit is
leaning too far
forward.
One or more of
the drawers are
not compeletly
closed.
Solution
Completely ctose all the
drawers and the tockbars
wilt release to open the
drawers.
Apply a downward
pressure to the top of the
cover to let the tockbars
release.
In an UNLOCKED
position and putt the lock
lever severat times.
Position the unit on a
level area.
Unlock the unit. Close
all drawers completely.
Retock unit.