Craftsman 706.813380 Operator's Manual page 4

i
J_
FRICTION SLIDES
Tab Styme - Fully extend the drawer. Insert screwdriver into
the slot in the side and push in on the stop until it clears
the lance. Pult drawer just past lance before
releasing stop. Repeat the process for the other slide.
Figure 12
Figure 8
REMOVING AND iNSTALLiNG DRAWERS
o Empty the drawer.
o Fully extend the drawer.
/Release Left
REINSTALL DRAWERS
Ball bearing slide = Putt slides and slide carrier out to fully
extended position (See Figure 13). Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and rectose to ensure proper operation.
slide carrier
Release Right
Figure 9
BALL BEARING SLIDES
Lever Style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Putt out to remove.
/
Figure 10 _- ..............
Tab Style - Depress the release tabs on both sides,
(this allows the slides to ride over the stops.)
Putt out to remove.
slide
Figure 13
Friction slide = Fully extend slides in cabinet. Hold the
slide on the cabinet while aligning it with the slide on
drawer. Push the drawer into the unit until the drawer
futty engages stides. Open drawer and reclose to ensure
proper operation. (If stop does not engage slide, lightly
deflect the stop with screwdriver.)
Slide
Figure 11 -_-_ ..........
Figure 14
Stop
/
/
/