Kenmore 110.28132410 Use & Care Manual page 11

8.
Select cycle
Steam model shown
Turn cycle knob to choose your wash cycle�
9.
Select cycle modifiers, if desired
Light soils Moderate soils
Colors that bleed Bright colors
or fade
Once you select a cycle, the default settings for that cycle
will be lit. Touch the cycle modifier buttons to change the
Wash Temp, Soil Level, and Spin Speed, if desired� Not all
settings are available with all cycles� Even for cold wash
settings, some warm water may be added to the washer
to maintain a minimum temperature�
NOTE: Always read and follow fabric care label instructions
to avoid damage to your items� If not sure which temperature
to use, refer to the diagram above or select a cooler temperature�
10
Steam model shown
Select any other cycle options you may wish to add, if not
previously set� Some cycles will automatically add certain
options such as Two Rinses. These may be turned off,
if desired�
NOTE: Not all options are available with all cycles�
11.
Touch and hold the Start/Pause/Unlock Lid button for up to
3 seconds to start the wash cycle. When the cycle has finished,
the Complete indicator will light and the end-of-cycle signal
will sound (if set). Promptly remove items when cycle is done
to avoid odor, reduce wrinkling, and avoid rusting of metal
Heavy Soils
hooks, zippers, and snaps�
Whites
Unlocking the lid to add garments
Pastels
If you need to open the lid to add 1 or 2 missed items:
Touch the Start/Pause/Unlock Lid button to pause the washer;
the lid will unlock once the washer movement has stopped�
This may take several minutes if the load was spinning at high
speed� Then close the lid and touch and hold the Start/Pause/
Unlock Lid button again for up to 3 seconds to restart the
cycle�
IMPORTANT: If the lid is left open for more than 10 minutes,
the water will pump out and the F8E6 error code will appear
on the display�
.
Select cycle options
Touch and hold Start/Pause/Unlock Lid
button to begin wash cycle
11