Fracarro 3DGFLEX Operating Instructions Manual page 25

First select the language of the WEB
interface menu (i.e. English, Italian,
French, German). From this menu,
you can see the general status of the
3DGflex headend.
The first module is the 3DG-CU control
unit and it is always present; the other
modules from position 1 to 6 might be
present or absent <red-danger>. If the
modules are present, this window also
shows their status.
The control unit shows the following:

• the symbol if it works properly
• the symbol if the memory is broken: in this case, we recommend not enabling the mo-
nitoring that might saturate the residual memory.
The hardware and software versions are reported under the name of the control unit (3DG-
CU). Select and click on the 3DG-CU control unit to enter the following window:
From the configuration menu, you can set the principal
parameters of the headend and the network.
In the "Installation setting" section, you can set the fol-
lowing:
• name of the installation, enter the name in the proper
box (by default, the name is 3DGflex)
• the contrast of the LCD display by using the up and
down arrow (the values range is from 1 to 16).
The software version of the control unit can also be di-
splayed.
25