Amplifier Connection; Maintenance; Replacing The Stylus - Madison MAD-RT300SP User Manual

AMPLIFIER CONNECTION

Connect audio plugs to the input on your mixer or amplifier:
Red plug into right channel input.

White plug into left channel input.

Playing a record
1. Place the record of your choice on the turntable. If it is a 45rpm, do not forget to place the adaptor on
the record spindle.
2. Choose the desired playing speed using the Speed select switch between 33.3, 45 and 78rpm.
3. Turn on the power of the turntable.
4. Release the tone arm lock.
5. Push the arm with your hand lightly.
6. Place the stylus vertically over the first track of the record the turntable will start turning automatically.
7. Put down the cartridge slowly to the record then the turntable will play.
8. When the record comes to the end, the turntable will stop automatically if the auto-stop switch is on
the ON position. If it is in the OFF position, the turntable will continue to spin even when the tone arm
is locked. This setting is suitable for LPs.
9. Lift up the tone arm and put it on the rest.
10. Replace the protective cap on the stylus and close the tonearm lock.
11. Turn off power at mains.
Bluetooth Function
Lift up the tone arm and put it on the rest. Then the BT function is ready for pairing.
Open your Bluetooth equipment and select MAD-RT300SP in the list of found device.
Choose your favorite songs with the , , , keys .
In this mode, the turntable mode will stop automatically.

MAINTENANCE

REPLACING THE STYLUS

-Refer to the figures 1-8
©Copyright LOTRONIC 2017 MAD-RT300SP 3