How To Use; How To Disassemble - Black & Decker JE2001 Use And Care Book Manual

Product may vary slightly from what is illustrated.


1. Fruit and vegetable feeder
2. Food Chute
3. Clear cover
4. Stainless-steel cutter/strainer
5. Pulp separator
6. Continuous flow juice spout
7. Juice container
8. Safety locking latch (on each side)
9. Non-slip rubber feet antidérapante
10. Removable pulp container
11. Off/Low/High ( pagado/Baja/ lta) control
12. Cord storage compartment
9





D O
A PA G A
B A JA
A LT A






How to Disassemble

1. To unlock the locking latches, pull open at the bottom of each
latch to disengage from the groove on the cover ( ).
DO
APAGA
BAJA
ALTA
2. To remove the cover, take out the feeder; grasp the chute and
pull up the cover (B).
B
3. To remove the pulp separator, grip the juice spout with one hand
and the back edge of the pulp separator with the other hand.
Pull it up with the cutter/strainer in place (C).
C
4. To remove the cutter/strainer, hold the juice spout with one
hand and grasp the cutter/strainer rim with the other hand;
pull it out (D).
Caution: The cutter/strainer teeth are very sharp. Handle it
D
carefully.
5. To remove the pulp container, grasp the sides firmly and slide it out.

How to Use

This appliance is for household use only.
The unit has a motor overheating protection system that automatically shuts off
the motor to protect it from overheating. Wait 5 minutes for unit to cool down.
Unplug the unit then plug again to resume operation.
Important: Before you use it for the first time, disassemble the unit (see How to
Disassemble section), wash all parts as instructed in the C RE ND CLE NiNG
section.
HOW TO SSEMBLE ND USE
1. Place the pulp separator on the base with the juice spout facing
you (E).
E
2. insert the cutter/stainer in the center of the pulp separator. Turn it
left and right a few times until it fits into place (F).
F
10