Drip Box - Kenmore 146.05349710 Use & Care Manual

Searing Burner
 Remove plastic packaging from searing burner valve. Remove searing burner grate from searing burner
shelf.
 Attach ignition wire to side burner valve. (A )Remove the 2 pre-installed screws from the valve control
stem and set them aside. (B)
 Loosen the searing burner to insert gas valve. First loosen and remove the screw attaching the electrode
to the shelf and set the screw aside. (C) Then loosen and remove the 2 screws holding searing burner in
place. (D)
 Insert the gas valve into the searing burner (E). Insert valve control stem through hole in fascia (F). Install
the 2 previously removed valve control stem screws, but do not fully tighten until attaching bezel to
fascia.
 Reattach searing burner to shelf with the 2 previously removed screws. (G) Reattach electrode to shelf
with previously removed screw from searing burner. (H)
 Insert bezel openings over valve control stem and the 2 screws. Slide bezel down onto screws. Make
sure that black mark on bezel is vertical. Tighten the 2 screws to secure bezel to fascia (I).
 Push control knob onto searing burner valve stem. (J)
 Replace searing burner grid. (K)
 Insert electrode wire into the head of electrode .(L)
 Slide searing burner drip box into the drip box bracket. (M)
 Unscrew igniter cap from side panel. Insert (1) AA battery (provided in hardware blister pack) into
battery slot with positive end (+) facing outward. (N)
A
A
C
C
E
E
26 • 05349-40500318
B
B
D
D
F
F