Reebok Elliptical Exerciser REL2i User Manual page 11

Select the desired mode
2
The scan
mode—
Repeatedly
press the
mode button
until an arrow
appears under
the scan sym-
bol. When the
scan mode is
selected, the console will display the speed, time,
distance, and calorie modes, for 5 seconds each,
in a repeating cycle.
The speed,
time, dis-
tance, fat
calorie or
calorie
mode—
Repeatedly
press the
mode button
until an arrow
appears below or above the desired mode sym-
bol. Make sure that there is not an arrow under
the scan symbol.
If desired, press the on/reset button to reset the
display.
Turn off the power
3
To turn off the power, simply wait for about
six minutes. If the pedals are not turned and the
buttons are not pressed for six minutes, the
power will turn off automatically.
All manuals and user guides at all-guides.com
Mode
Button
Mode
Arrow
Mode
Button
Mode
Arrow
HOW TO SELECT KILOMETRES OR MILES
The console can display distance and speed in either
kilometres or miles.
To change the unit of measurement, first remove the
six screws attaching the console (refer to the drawing
below). Lift the console a few inches and turn it over;
be careful not to pull on the wires. Next, locate the
small switch on the back of the console. Slide the
switch up or down to change the unit of measurement.
Re-attach the console with the six screws; be careful
not to pinch any of the wires.
Switch
11