Dirt Devil DUSTY 360 DD1400 Operating Manual page 34

4 After use
16
17
34
6. Separate the coarse filter and the fine filter
of the dual pre-motor filter from each other
(fig. 16).
7. Rinse the dust bin, the separator and both
filter components of the dual pre-motor fil-
ter thoroughly under running, lukewarm
water.
8. Use this opportunity to clean the exhaust
filter at the same time
„Cleaning the exhaust filter".
NOTE:
If you see that one of the filter elements is
damaged, replace
( chapter 5.2, „Ordering spare parts").
9. Leave the components to dry for approxi-
mately 24 hours at room temperature after
cleaning them with water. Do not replace
them until they are completely dry.
CAUTION:
Never operate the appliance without all the
filter components correctly installed. There
is a risk of damage to the motor.
10. Insert the coarse filter back in the fine filter
(fig. 16).
11. Lower the separator all the way into the
dust bin (fig. 17). Make sure that the open-
ings of the dust bin and the separator are
aligned (fig. 17/arrow).
chapter 4.3,
it immediately