Setting Up Your Phone; Raising The Antenna; Adjusting Ringer/Volume Controls - Sanyo CLT-9920 Instruction Manual

900-mhz digital spread spectrum cordless telephone
Hide thumbs Also See for CLT-9920:
Table of Contents

Advertisement

All manuals and user guides at all-guides.com
CLT9920 (SANYO) A5 2nd
Handset retainer
8
On the base unit, pull the handset retainer out
of the slot. Rotate it clockwise 180 degrees.
9
Flip it over. Slide it back into the slot so that the
lip of the retainer is up and the
down. The retainer holds the handset in place.
When the belt clip is attached onto
the handset, you can hang the hand-
set on the wall-mounted base with
the keypad facing inside only.

Raising the Antenna

Before using your phone, be sure to raise its anten-
na fully to the vertical position.
Adjusting Ringer/Volume
Controls
Ringer Tone and Volume
1
While the phone is not in use, press VOLUME
or
.
2
The phone has two ringer tones, each with two
volume levels. Press VOLUME
again until you hear the ringer tone and vol-
ume level you want.
6/29/00
10:06 AM
Page 6
Direct wall plate mounting
If you do not have a standard wall plate, you can
mount your phone directly to the wall. Before doing
this, consider the following:
• Avoid electrical cables, pipes or other items
behind the mounting location, that could cause a
hazard when inserting screws into the wall.
• Try to mount your phone within 10 –15 feet of a
working phone jack to avoid excessive cord
lengths.
• Make sure the wall material is capable of support-
ing the weight of the base and handset.
• Use #10 screws with anchoring devices suitable
for the wall material where the base unit will be
placed.
points

Setting Up Your Phone

Setting the Handset Earpiece Volume
1
While you are on a call, press VOLUME
or
2
The phone has four receiver volume levels,
Normal, Medium, High, and Loud. Press
VOLUME
hear the volume level you want.
When you hang up, the phone keeps the last
volume setting selected.
or
E5
1
TOP
Insert two mounting
3/16 in.
screws with a minimum
(4.8 mm)
length of 1-3/8 inches
(35.5 mm) into the wall,
3-15/16 inches (100
3-15/16 in.
(100 mm)
mm) apart. Allow about
3/16 of an inch (4.8 mm)
between the wall and
screwheads for mount-
ing the phone.
2
Refer to steps 1 through
9 on page 4 and 5 to
mount the telephone.
.
or
repeatedly until you

Advertisement

Table of Contents
loading

Table of Contents