Table of Contents
Advertisement
Quick Links
Installation Manual
·
It is imperative that the installation instructions within this manual are followed for
safety reasons. Vivitek Corporation is not responsible for damages resulting from
incorrectly installed mounts or projectors on to the mount.
·
Sufficient expertise is required for installing this projector wall mount.
·
Do not use the projector wall mount for purposes other than for which it is designed.
· ·
Please contact Vivitek at 1-855-885-2378 with any questions pertaining to the correct
installation of this projector mount.
46101 FREMONT BLVD, FREMONT, CA. 94538 - TEL 855.885.2378 - EMAIL:
Model: WM-3Z and LT30B-G
PROAV@VIVITEKCORP.COM
- WWW.VIVITEKUSA.COM
Advertisement
Table of Contents
Related Manuals for Vivitek WM-3Z
Summary of Contents for Vivitek WM-3Z
-
Page 1: Installation Manual
Do not use the projector wall mount for purposes other than for which it is designed. · · Please contact Vivitek at 1-855-885-2378 with any questions pertaining to the correct installation of this projector mount. 46101 FREMONT BLVD, FREMONT, CA. 94538 - TEL 855.885.2378 - EMAIL: PROAV@VIVITEKCORP.COM... - Page 2 Important Safety Checking The Supplied Accessories diagrammatic quantity designation presentation Screw (M6X55) Φ10mm Anchor bolt Fixed Support Arm X 1 Wall Plate X 1 Wall Cover X 1 L5 Allen key L3 Allen key M4X10) Screw Screw (M6X12) M4 connecting screw Projector Mounting Plate X 1 Wall Plate Cover X 1...
- Page 3 Checking The Installation Position 1080p (DH765Z-UST & DH768Z-UST) Projection image size Installation distance Vertical Offset L1 (From Screen surface to L2 (From Screen surface to Diagonal(D) Width x Height (V-Offset) the rear of the projector) the rear of the projector) inch (cm) inch (cm) inch (cm)
- Page 4 ● The bracket is suitable for concrete wall mounting or wooden stud wall. ● Concrete wall mounting thickness must be a minimum 4'' (100mm). Anchor bolt and screw (M6 × 55) are needed to be used for concrete wall installation. ●...
- Page 5 ● ● You can adjust the projector upward/ Tighten the screw “F” after locating -downward according to your need. the projector position. Sliding distance of adjusting the projector upward/downward: 3.15''(80mm) To Install The Projector On The Projector Wall Mount If the surface is not at, pls use the “G”...
- Page 6 To Install The Projector On The Projector Wall Mount Power cable and signal cable Tighten the screws Connect power cable and other signal cable to projector To Adjust The Projector Forwards/Backwards Check the scaleplate to see the distance from mounting plate to the wall. Note: To make adjustments to meet your demands, screws must be loosened in a specific order.
- Page 7 To Adjust The Projector Upwards/Downwards Screen Adjustment Direction To Adjust The Vertical Tilt Knob Screen Adjustment Direction Adjustment Knob To Adjust The Horizontal Roll Knob Adjustment Knob Screen Adjustment Direction Pg.7...
- Page 8 But the wall cover must be used in an specific order as the picture on the left shows. Finally, put the wall cover on. Product Information Model LT30B-G WM-3Z Product Weight 9.9lbs (4.5kg) 12.13lbs (5.5kg) Load Capacity...
Need help?
Do you have a question about the WM-3Z and is the answer not in the manual?
Questions and answers