Advertisement

Quick Links

Installation Manual
It is imperative that the installation instructions within this manual are followed for
safety reasons. Vivitek Corporation is not responsible for damages resulting from
incorrectly installed mounts or projectors on to the mount.
Sufcient expertise is required for installing this projector wall mount.
Do not use the projector wall mount for purposes other than for which it is designed.
Please contact Vivitek at 1-855-885-2378 with any questions pertaining to the correct
installation of this projector mount.
46101 FREMONT BLVD, FREMONT, CA. 94538 - TEL 855.885.2378 - EMAIL:
Model:WM-3
PROAV@VIVITEKCORP.COM
- WWW.VIVITEKUSA.COM

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WM-3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Vivitek WM-3

  • Page 1 Do not use the projector wall mount for purposes other than for which it is designed. ● Please contact Vivitek at 1-855-885-2378 with any questions pertaining to the correct installation of this projector mount. 46101 FREMONT BLVD, FREMONT, CA. 94538 - TEL 855.885.2378 - EMAIL: PROAV@VIVITEKCORP.COM...
  • Page 2 Important Safety Checking The Supplied Accessories Fixed Support Arm X 1 Wall Plate X 1 Wall Cover X 1 diagrammatic designation quantity presentation (M6X55) Screw Φ10mm Anchor bolt L5 Allen key L3 Allen key (M4X10) Screw Projector Mounting Plate X 1 Wall Plate Cover X 1 (M6X15) Screw...
  • Page 3 Wall plate must be aligned to center of screen Wall plate Bottom of V-Offset mounting plate V-Offset Top of image Projection screen Projection screen WM-3 Mount Image Size Projector V-Offset Resolution (Distance between bottom of wall plate to top of image) Diagonal Width Height 13”(33cm)
  • Page 4 ● The bracket is suitable for concrete wall mounting or wooden stud wall. ● Concrete wall mounting thickness must be a minimum 4'' (100mm). Anchor bolt and screw (M6 × 55) are needed to be used for concrete wall installation. ●...
  • Page 5 ● ● You can adjust the projector upward/ Tighten the screw “F” after locating -downward according to your need. the projector position. Sliding distance of adjusting the projector upward/downward: 3.15''(80mm) To Install The Projector On The Projector Wall Mount If the surface is not at, pls use the “G”...

Table of Contents