Table of Contents
Advertisement
● The bracket is suitable for concrete wall mounting or wooden stud wall.
● Concrete wall mounting thickness must be a minimum 4'' (100mm). Anchor bolt and screw (M6 × 55) are
needed to be used for concrete wall installation.
● Dry-wall wall thickness must be a minimum 4.5" (114mm). Only screw(M6 × 55) is needed to be used for
installation, and gypsum board thickness less than 0.59" (15mm).
If the wall is not strong enough, reinforce it sufficiently before installation.
● Please contact reseller if you have any questions
about mounting surface issue.
Take off the cap
Loosen the screw
The arrows up
screw (M6 × 55) are needed
for installation in concrete wall mounting
D
The cables
Loosen the screws with L3 allen wrench,
pull out the support arm around
and make power cable & signal cables go
through the support arm.
Pg.4
When installation on the
wood stud wall, Align the
center of the wall mount
plate with the center of
the stud.
A
C
The arrows up
The cables
The cables can be got through the wall plate
4'' (100mm)
by three ways as shown in the pictures. Then,
Lock the screw "F" , but not tighten it.
>55mm
ø10~11mm
Concrete wall mounting
>55mm
ø3mm
Dry-wall mounting
screw central point
screw (M6 × 55) are needed
for installation in dry-wall mounting
B
Use anchor bolt
Not use anchor bolt
A
C
The cables
Advertisement
Table of Contents
