Scientific Atlanta PowerVu D9228 Installation And Operation Manual page 89

Alt Mode Operation
ALT Mode 1
Key Function
0 Input (RF#1, RF#2, ASI)
1 C/Ku (display)
2 FEC (display)
3 BER : (display)
4 FRQ (fine tuning)
5 SYM : display/Edit symbol
rate
6 SIG Level (display)
7 FRQ
8 POL : display/Edit
polarization
9 AFC : Error Rate (display)
707-161 Rev. 3
(continued)
Description
Displays the current input source. You can switch
between the three input sources by using the up and
down arrow keys. You can also alter this setting in the
Configuration Menu.
Displays whether the MDR is tuned to C band or Ku
band. It is also displayed in the RF-1 or RF-2 Setup
Menu.
Displays the FEC rate. You can switch the FEC rate by
using the up and own arrow keys. You can also edit the
FEC rate in the LNB-1 or LNB-2 Setup Menu.
Displays the bit error rate (BER). It is also displayed in
the LNB-1 or LNB-2 Setup Menu.
Displays the currently tuned frequency. Increment or
decrement the frequency in 1MHZ steps using the up or
down arrow keys. Press YES again to save. You can also
edit the frequency in the LNB-1 or LNB-2 Setup Menu.
Displays the current symbol rate. You can edit the
symbol rate with the numeric keypad. To edit, press
YES. Enter the desired symbol rate with the numeric
keypad. Press YES again to save. You can also edit the
symbol rate in the LNB-1 or LNB-2 Setup Menu.
Displays the signal level. This is also displayed in the
LNB-1 or LNB-2 Setup Menu.
Displays the tuned frequency. Edit the frequency by
pressing YES, enter the new frequency on the numeric
keypad, then press YES again to save. You can also edit
the frequency in the LNB-1 or LNB-2 Setup Menu.
Displays the set polarity (horizontal or vertical). Use the
arrow keys to alter the polarity. You can also edit the
polarity in the LNB-1 or LNB-2 Setup Menu.
Displays the AFC error rate. The error rate is also
available in the LNB-1 or LNB-2 Setup Menu
Alt Mode Operation
continued on next page
C-3