Connection With The Mains; Operation; Cleaning And Maintenance - EuroLite LED IP BCO-1 User Manual

Procedure: (for mounting via ground stake)
Step 1: Loosen the fixation screw of the stake with the enclosed Allen key and remove the washer disk
and the fixation screw.
Step 2: Place the stake onto the mounting bracket, place the washer disk on the other side of the
mounting bracket and tighten the fixation screw with the Allen key.
Step 3: Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Step 4: Install the device at the desired installation-spot.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power-plug. Make sure that the outlet is in a dry area.

OPERATION

After you connected the LED IP BCO-1 RGB Beam Effect to the mains, the device starts running.
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only in
order to avoid hazards.
Should you have further questions, please contact your dealer.
DANGER TO LIFE!
DANGER OF FIRE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
11/12 00091587, Version 1.0