Table of Contents
Advertisement
CE
Hereby, Suunto Oy declares that the radio equipment type OW175 is in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: www.suunto.com/EUconformity.
• Frequency band: 2402-2480 MHz
• Maximum output power: <6 dBm
• Range: ~3 m
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. This product has been tested to comply with FCC
standards and is intended for home or office use.
Changes or modifications not expressly approved by Suunto could void your
authority to operate this device under FCC regulations.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ISED
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
6
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
DATE OF MANUFACTURE
The manufacturing date can be determined from your device's serial number. The
serial number is always 12 characters long: YYWWXXXXXXXX.
In the serial number, the first two digits (YY) are the year and the following two
digits (WW) are the week within the year when the device was manufactured.
DISPOSAL
Please dispose of the device in accordance with local regulations for
electronic waste. Do not throw it in the garbage. If you wish, you may return
the device to your nearest Suunto dealer.
CHINA ROHS II
Component
Name
Lead
Mercury
Cadmium
(Pb)
(Hg)
(Cd)
Watch
X
O
O
PCBA
USB cable
X
O
O
connector
This table is prepared in accordance with the provisions of SJ/T 11364.
O - indicates that said hazardous substance contained in all of the homogeneous
materials for this part is below the limit requirement of GB/T 26572.
X - indicates that said hazardous substance contained in at least one of the
homogeneous materials for this part is above the limit requirement of GB/T
26572.
Hazardous Substances
Chromium VI
Polybrominated
Polybrominated
Compounds
Biphenyls
Diphenyl Ethers
(Cr(VI))
(PBB)
(PBDE)
O
O
O
O
O
O
7
Advertisement
Table of Contents
