Driving; Tilting; Changes & Adjustments; Set Up, Adjustment & Use - Sunrise Medical Quickie P-220 User Instruction Manual & Warranty

6
A. SOLID SEAT BACK
Do not use the Solid Seat Back to push or lift the wheelchair. Improper use
may cause the back to unexpectedly detach from the wheelchair.
B. DRIVING
You should drive your chair with the tilt at the minimum angle.
C. TILTING
To prevent damage and personal injury, avoid tilting near objects such as
walls, tables or chairs.
To avoid injury, ensure other people, especially children, are clear of the system.
If using a swing-away abductor, be sure not to tilt with the abductor swung away.
Otherwise, the abductor may collide with the tilt actuator when returning to the
untilted position.
D. CHANGES & ADJUSTMENTS
Never use non-Quickie parts or make changes to your chair unless authorized
by Sunrise. (Doing so will void the warranty and may create a safety hazard.)
1. If you modify or adjust this chair it may increase the risk of fall or tip-over.
2. Modifications unauthorized by Sunrise constitutes remanufacturing of the
wheelchair. This voids the warranty. The rider then assumes all future liability
for the wheelchair.
930478 Rev. A
All manuals and user guides at all-guides.com
I V . W a r n i n g s V . S e t - u p , A d j u s t m e n t & U s e
TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set up, adjust and maintain your chair you will need
the following tools:
• 5/32" Allen wrench
• 3/16" Allen wrench
• 5/16" Allen wrench
• 9/16" box and open-end wrench
• 1/2" box and open-end wrench
• Phillips screwdriver #1
• Standard slot screwdriver
NOTE– Setting the wheelchair on a flat surface, such
as a table or a workbench, helps make these
procedures easier.
A. BATTERY REMOVAL
To remove the batteries for transporting or servicing:
Remove Batteries
a. Remove seat and main frame from power drive
unit using quick-release levers (C).
b. Lift battery compartment lid (E) off of power
drive unit.
c. Prevent the power drive unit from tipping for-
ward by placing a solid object underneath the
front of the power drive unit.
d. Disconnect battery leads from power harness.
e. Lift rear most battery out using the battery
straps (F).
f. Pull the front battery rearward, disconnect it,
and remove it using the battery straps.
Batteries may weigh up to 55 lbs. (25 kg).
Care must be taken to avoid injury when lifting.
7
C
E
F
930478 Rev. A