Mixdown; Rec Function; Output Level - Tascam Porta02 MiniStudio Owner's Manual

3 Making your first recording
3.7

Mixdown

18
Make sure that your mastering recorder is connected to the monitor-
ing system.
1) Set both

REC FUNCTION

faders down to
This will stop any extra unwanted noise from the inputs appearing in
the final mix.
2) Make sure the mastering recorder is ready to record, and
put it into record pause mode. Do not start recording yet.
If you are using a tape for mastering, make sure that you are not
recording over anything you want to keep. If you are using a new tape,
make sure that you have taken the tape past the leader portion. Make
the noise reduction, etc. settings on the mastering recorder, which will
give you the best sound quality.
3) Play back the recording on the Porta02 and adjust the

OUTPUT LEVEL

The nominal position (the best position) for the
about the 2 to 3 o'clock position. This is the position you should
regard as normal.
It is usual to put the
fully right and fully left. You can place the two voices anywhere in the
stereo picture.
Practice adjusting the levels of tracks 3 and 4 together to fade the
backing music in and out.
4) While adjusting the levels on the Porta02, watch the
recording levels on the mastering recorder. If they are too
high, take down the recording level on the mastering
recorder.
Remember that if you are recording on a digital recorder, such as an
MD recorder, if the signal levels are too high, the result will be
extremely unpleasant distortion. Analog recorders, such as cassette
decks, will also distort if the levels are too high, but the distortion is
much more pleasant (even so, you should try to avoid distortion in the
mixdown).
5) When you are happy with the mix rehearsal, rewind to the
start of the recording on the Porta02.
6) Start recording on the mastering machine, and start
playback on the Porta02.
switches to
.
0
and controls on the Porta02.
PAN
PAN controls for a stereo source such as a CD
, and move both
SAFE
LEVEL controls is