Related Manuals for PSA LIFESAVER LIFWMB2
Summary of Contents for PSA LIFESAVER LIFWMB2
-
Page 1: Quick Start Guide
Quick Start Guide LIFWMB2 Interlink Network Setup Please Read All Instructions First! - Page 2 Section 1 Quick Start RF Interlink Network Setup Section 2 Adding a Device to an Existing RF Interlink Network Section 3 Resetting a Device...
- Page 3 LINK button Power Up ONE Device Connect one smoke alarm to the LIFWMB2 RF baseplate. Baseplate LINK button Red LED will ash on/o every second.
- Page 4 Push button twice On the First Powered Device Push the LINK button two times on the rst powered device. 2 Red LED ashes every 2 seconds . This is the network coordinator. Join Mode is open.
- Page 5 Power up Remaining Devices Power up all of the remaining RF baseplates by connecting them completely on the smoke alarm. Red LED ashes 3 times every 2 seconds after joining the network.
- Page 6 Push button twice Pick Any Device Push the LINK button twice on any unit after all the smoke alarms have joined the network. Red LED stops ashing on each unit as network is closed.
-
Page 7: Setup Complete
Setup Complete! If all devices are no longer ashing the Red LED, the devices are now connected. Congratulations! Refer to user guide for detailed installation instructions. - Page 8 Section 2 Adding a Device to an Existing RF Interlink Network...
- Page 9 Push button twice Push LINK Button Twice on any installed unit. To open the RF Interlink Network, push the LINK button twice on any previously connected smoke alarm Red LED ashes every 2 seconds. Join Mode is open.
- Page 10 Power On the New Device(s) Connect the smoke alarm to the new RF baseplate. Red LED ashes 3 times every 2 seconds after joining the network.
- Page 11 Push button twice Choose ANY Connected Device Push LINK button twice on any connected device to close the network. Red LED stops ashing on each unit as network is closed.
- Page 12 Setup Complete! If all devices are no longer ashing the Red LED, the devices are now connected. Congratulations! Refer to user guide for detailed installation instructions.
-
Page 13: Resetting Your Device
Section 3 Resetting Your Device If you encounter an issue at any point during the RF Interlink network setup process, or if you need to remove a device from a network, you may reset the device by following the subsequent directions. -
Page 14: Resetting The Device
Push button twice Resetting the Device Push LINK button twice to open Join Mode. Unit will respond with 2 or 3 ashes, indicating Coordinator or RFD respectively. - Page 15 Push and hold button Resetting the Device Press and Hold button for 4 to 5 seconds. Unit will respond with 4 quick ashes indicating that the wireless settings have been reset and the unit is now a standalone alarm. Device has been put in General Reset Condition. See User Guide for complete instructions on how to return to a network...
- Page 16 Need more help getting started? Visit www.psaproducts.com.au to view video tutorials. Consult the User Guide for more detailed instructions on product installation and use.