Recording; Inserting An Sd Card; Recording On An Sd Card - Tascam BB-1000CD Owner's Manual

2–Quick start guide

Recording

Recording by using the built-in microphones is explained
in the example below.
You can also use external microphones connected to the
/
EXT MIC A(L) EXT MIC B(R)
ment connected to the
LINE IN
the unit as recording sources.
1.
Press the key to open the
INPUT
2.
Press the
CURSOR [ § / ¶
item.
3.
Turn the wheel to select "
DATA
The built-in microphones on the front and rear
( and
FRONT MIC REAR MIC
source.
4.
Press the key to return to the Home screen.
INPUT

Inserting an SD card

The SD card slot and the CD slot are equipped on the right
side of the unit.
Insert an SD card in the SD card slot and push it until it
clicks fully into place.
Removing the SD card
Press the inserted SD card in gently and it will disengage
from the unit so that you can completely pull it out.
NOTE
Do not remove the SD card during recording and playback, and
while the SD indicator is fl ashing (writing data).
20
TASCAM BB-1000CD
terminals and audio equip-
terminal on the left side of
screen.
INPUT
key to select the
] SOURCE
".
FRNT/REAR
) are set to the recording

Recording on an SD card

Before recording, insert an SD card into the unit and press
the key to change the recording media to SD card.
SD
NOTE
It is recommended to format an SD card on the unit before record-
ing on the card ( ∑ page 49 "Formatting an SD card").
Using an SD card formatted on other devices or a PC may increase
the possibility of recording errors.
1.
Press the
º
REC/READY [
The unit becomes on standby for recording. The
Record screen appears and
flashes.
2.
Check the level meter and adjust the input level by
turning the
FRONT MIC/EXT MIC
knob.
MIC/LINE
The input level is indicated on the
The indicators upper left of the knobs light when the
input is too loud. Set the input level a little less than
that makes the indicators lit at inputting maximum
volume.
key.
]
key
REC/READY [ º ]
knob and the
REAR
meter.
L/R