GDS Corp C2 Quad Protector Quick Start Manual

Quickstart Guide
C2 Quad Protector Controller with
Remote GASMAX II Gas Monitor
C2 QUAD ANALOG INPUT BOARD
P/N #10-0221-4
Important:
The GASMAX II output is
polarized. Take care in
connecting the +24VDC
source, 4-20mA output and
ground reference wiring.
GDS Corp. 2513 Hwy 646 Santa Fe, Texas 77510
Wiring & Initial Setup Instructions
1) Install the C2 Quad Protector controller and remote
GASMAX II monitor. As with all sensors, avoid
locations subject to excessive heat, directed water
spray or dust. A splash guard is recommended on
all externally-mounted sensors.
2) Connect the C2 Quad Protector input terminals to
the remote GASMAX II monitor as shown below.
3) Make sure the selected C2 channel is set to
"ON" (see the C2 manual, section 2.2.4d).
4) Calibrate the unit to verify proper operation.
www.gdscorp.com
C2
I/O Power Supply
Assy 10-0233
1 2 3 4
Ribbon to Display
TB2
C8
GASMAX II POWER SUPPLY
ASSEMBLY BOARD
P/N #10-0233
(409) 927-2980
info@gdscorp.com
C1
CATBEAD
S2
TB1
C7
S1
(409) 927-4180 fax