GE MDS P-60 Reference Manual page 66

66
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8466-MDS-P60-Compact-Enclosure-(One-Radio).aspx
3. Measure the voltage present at the cathode of the large diode (CR9 on
Analog boards, CR1 on Digital boards), referenced to power supply nega-
tive. This voltage should be 14.10 Vdc; if not, the power supply voltage
should be adjusted to produce 14.10 Vdc at the cathode (banded end) of
the diode. The power supply output voltage can be adjusted with voltage
adjustment pot R11 within the AC power supply unit (accessible through
the hole on the side of its cover).
4. Remove the 1.5 k resistor from J4 and re-install the mating battery con-
nector into J4.
5.11 Service Drawings and Reference Data—
MDS P-50
This section contains assembly drawings and wiring diagrams for the MDS
P-50 packaged system. Additionally, schematic diagrams are included for the
Analog and Digital Interface/Utility Boards.
Figure 35. MDS P-50 Interior View
MDS P-60/P-60 HL Reference Manual
Invisible place holder
MDS 05-2818A01, Rev. C