Table of Contents
Advertisement
28
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8466-MDS-P60-Compact-Enclosure-(One-Radio).aspx
FLAT WASHER
(4 REQ’D)
LAG SCREW
TO PRIMARY POWER
(CONDUIT)
Figure 13. Typical Wall Mount Installation (MDS P-50)
Pole Mounting Instructions
Standard pole mounting requires the use of two pole-mount adapters (P/N
82-1743A01). These brackets must first be bolted to the MDS P-50 enclosure.
The complete assembly can then be mounted to a wooden utility pole with two
lag screws or with two long bolts that extend through the pole. (Threaded rod
can also be used for through-the-pole mounting.) In either case, it is important
to use flat washers with the attaching hardware (fasteners are not supplied).
To pole mount the unit, follow these instructions:
1. Attach the two pole mount adapter brackets to the MDS P-50
enclosure with suitable nut and bolt assemblies, as shown in
.
Figure 14 on Page 29
2. With the help of an assistant, position the MDS P-50 enclosure on the pole
at the desired mounting point.
3. Install the attaching hardware (with flat washers) in the center hole of the
two brackets.
4. Tighten the fasteners securely, but do not over-tighten.
MDS P-60/P-60 HL Reference Manual
Invisible place holder
COAXIAL CABLE
TO ANTENNA
TO DATA EQUIPMENT (RTU)
MDS 05-2818A01, Rev. C
Advertisement
Table of Contents
