Table of Contents
Advertisement
MDS 05-2818A01, Rev. C
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8466-MDS-P60-Compact-Enclosure-(One-Radio).aspx
Figure 14
shows a typical pole-mount installation using lag screws.
FLAT WASHER
(2 REQ’D)
LAG SCREW
NUT & BOLT ASSEMBLY
(4 REQ’D)
TO PRIMARY POWER
(CONDUIT)
Figure 14. Typical Pole-Mounted Installation (MDS P-50)
Other pole-mount configurations are available for the MDS P-50, including a
mounting bracket with a sun shield (for use in excessively hot climates), a
tower mounting bracket, and other arrangements to meet special needs. Con-
tact GE MDS for more information.
Rack Mount Alternative
In addition to wall and pole mounting, the internal chassis of the packaged
system can also be mounted in a standard 19 inch equipment rack for indoor
installations. The rack-mounted model is normally shipped without an enclo-
sure and is supplied with hardware for mounting the chassis plate to the rack
cabinet.
Figure 15
on
Page 30
Figure 16
on
Page 31
details the mounting plate configuration.
MDS P-60/P-60 HL Reference Manual
Invisible place holder
shows a typical rack mount installation, and
COAXIAL CABLE
TO ANTENNA
POLE MOUNT
BRACKET
82-1743A01
(2 REQ’D)
TO DATA
EQUIPMENT (RTU)
29
Advertisement
Table of Contents
