Connecting To The Data Port Command Interface Using Telnet - TANDBERG D1392602 User Manual

TANDBERG Video Portal Data port Command Interface User Guide
3.

Connecting to the Data port Command Interface using Telnet

The TANDBERG Video Portal has one LAN port.
The Video Portal's Telnet server provides access to the Data port Command Interface through a 10/100 base T
network interface supporting the TCP/IP protocol.
When connected to the Video Portal, type tsh to start a t-shell from the command line. The Telnet client will receive
a welcome message similar to the following:
Welcome to <System Name>
TANDBERG Video Portal Release V3.0
SW Release Date: 2007-03-13
NOTE! If the TANDBERG Video Portal has been protected with an IP password you will be prompted to enter this
password before you can access the Data port Command Interface via Telnet.
D1392602 6