TANDBERG D1392602 User Manual page 28

TANDBERG Video Portal
Dial
DialplanEntryDelete
DialplanEntrySwap
DisconnectCall
D1392602
This command establishes a dial out to an end point
Parameters:
•
CalledParty: <S:0, 60> End point to be connected with the service.
•
CallingParty: <S:0, 60> Service telephone number.
•
NetType: <All/H324m/H323/SIP> Nettype of the end point to be called.
•
CallType: <Tlph/Vtlph> Call type is either voice (Tlph), or voice and video (Vtlph).
OK Result parameter:
•
Session ID: <S: 1.. 50>
Example:
xCommand Dial CalledParty:0612345678 CallingParty: 0207947123 Nettype: H324m Calltype:
Vtlph
*r Result (status=OK):
Dial: "dial:904023_5"
*r/end
OK
This command deletes the indicated entry of a dialplan.
Parameter:
•
DialplanEntryNumber: <1..64>
Example:
xCommand DialplanEntryDelete: 1
*r Result (status=OK): /
*r/end
OK
This command swaps two dial plan entries in the dial plan list.
Parameters:
•
DialplanEntryNumber: <1..64>
•
DialplanEntryNumber2: <1..64>
Example:
xCommand DialplanEntrySwap 1 3
*r Result (status=OK):
*r/end
OK
This command disconnects a call either via the Session ID or the Call Leg ID.
Parameter:
•
CallID: <S: 0, 50> Either the Call leg ID or the Session ID.
Data port Command Interface User Guide
28