CONTENTS SAFETY WARNINGS AND GUIDELINES ................3 INTRODUCTION .......................... 4 PACKAGE CONTENTS ......................4 PRODUCT OVERVIEW ......................5 USING THE MENU SYSTEM ....................5 Installation ............................. 6 SETUP ............................7 SOFTWARE INSTALLATION AND SETUP ................10 Installing Cura for Windows ....................10 Repetier-Host ..........................
SAFETY WARNINGS AND GUIDELINES Be careful not to damage the PC paper on the build plate. Take care to avoid touching hot parts, including heat blocks, extruder nozzle, extruded filament, and the heated build plate. Do not wear gloves when operating or repairing to avoid entanglement. ...
INTRODUCTION Thank you for purchasing this 3D printer from Malyan! This printer features a single extruder, which is capable of printing in PLA, ABS, and other materials. You can print from a Windows® or Mac® PC using a USB connection or can print from 3D model files stored on a memory card, without the need for a PC connection of any kind.
PRODUCT OVERVIEW 1. Extruder 5. Input Power Jack 2. LCD Screen 6. Filament Rack 3. Micro USB and Micro SD Ports 7. Feed Mechanism 4. Power Switch USING THE MENU SYSTEM Rotating the control wheel counterclockwise moves the highlight/pointer to the up. ...
Installation 1. Use 4.0mm Hex Wrench and 8 pieces M4*6 screw to fix two metal frame on the each side of the printer.(4 pieces of each side) 2. Use the 2.5mm Hex wrench to lock the 4 pieces M5*20 screw on the bottom of the base.(2 pieces of each side) 3.
SETUP Perform the following steps to prepare the printer for use. 1. Put the printer on a flat, stable surface with plenty of ventilation and a nearby AC power outlet. 2. Ensure that the power switch is in the OFF position. Plug the included AC Power Cable into power jack on the right side of the printer, then plug the other end into a nearby AC power outlet.
Page 8
10. Using the same procedure, set the Bed temperature to the target temperature for your filament type. 11. Rotating the control wheel counterclockwise to move the highlight to Control, press the center of control wheel to back to the previous menu. 12.
Page 9
The nozzle is too far from the platform. This can result in the Wrong extruded material not sticking to the build platform. The nozzle is at the correct height Correct above the platform. The nozzle is too close to the Wrong platform.
SOFTWARE INSTALLATION AND SETUP As you've seen, you can print a model directly from a gcode file on the included memory card and this is the preferred method, as it does not require a continuous connection to your computer. You can download gcode files to the memory card and print them without having to build any model files.
Page 11
5. Click Finish to complete the installation and launch the program. 6. Run the Cura, click Settings > Printer>Add Printer. 7. Click the Other option, then choose the Malyan MA10, then click the “Add Printer” button to continue.
Page 12
8. The detail of Machine Settings will show on the screen, click the Close. Then you can use the Cura to print the model.
Repetier-Host You can also install Repetier-Host from the file on the included memory card or download from the internet. The screenshots below show the proper settings to use for this printer in Repetier-Host.
FCC Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the MA10 and is the answer not in the manual?
Questions and answers