Celestron 44423 Software Manual page 12

3. Special commands:
A.
i. Delete Available Units of Measurement:
ii. X Direction:
iii. Y Direction:
iv. Demarcation Adjustment:
trim size (unit length per pixel) will change.
v. Y=X:
Makes the X-axis ruler equal to the Y-axis ruler.
vi. Save To:
Save the currently demarcated parameter to a file.
vii. Load From:
12 | ENGLISH
: Selecting the Calibration command opens the Ruler Setting window. With this window, you can
use a standard microscope calibration ruler or other ruler with sufficiently small graduations to
calibrate your software's measurement functions.
The length along the X axis.
The length along the Y axis.
Move the movable points (in the blue circle) of the ruler seen in the image, and the value of
Load a previously demarcated parameter file.
um/mm/cm/inch.