PELSTARONE-P ® Thank you for purchasing this Health o meter Professional product. Please read this manual carefully, and keep it for reference or training. TABLE OF CONTENTS CAUTIONS AND WARNINGS ..................... 3 CERTIFICATIONS AND DISPOSAL……………………………………………………………...3 PACKAGE CONTENTS ...................... 4 SET UP INSTRUCTIONS ....................5 OPERATING INSTRUCTIONS ....................
Please read carefully. Be sure to use the specified battery and power source provided by Health o meter Professional Scales. Connection to an improper power source may cause fire, explosion or damage to the printer.
PACKAGE CONTENTS To avoid damaging the PELSTARONE-P when unpacking it, do not use a box cutter, knife, scissors or any sharp object when opening the protective inner packaging. If damage is found, contact ® your shipper or a Health o meter Professional representative immediately.
SET UP INSTRUCTIONS Note: If multiple printers were purchased, do not mix and match the wireless adapters (blue box) and printers. Each printer has been paired to communicate with a specific adapter. 1. Connect the “A” end of the SCALE CABLE (1 ft.
Page 6
SET UP INSTRUCTIONS 3. Connect the USB Wall Power Adapter onto the “A” end of the 6 ft. POWER CABLE, and then connect the “B” end of the POWER CABLE to the HOMBT1 Scale Unit “Power In” Port. (Note: This provides power to the HOMBT1 Scale Unit) 4.
Page 7
SET UP INSTRUCTIONS (CONTINUED) Powering the Printer Before first use, the protective tape must be removed from the power nodes on the battery. To access the battery compartment, place the printer upside down on a flat surface. Push down on the tab to open the battery compartment.
SEND button to begin printing (weight, height and BMI data will print). Troubleshooting Before contacting service personnel, refer to the following instructions to check for connectivity ® and transmission status. If you have further questions, call Health o meter Professional Scales Customer Service at 1-800-815-6615. Data Transmission LED...