Cisco WAP581 Administration Manual page 81

Fast Roaming
Step 5
Repeat steps 1 through 4 and then configure the R1 key holder in the Remote R1 Key Holder Data List. A maximum of
10 entries of R1 key holders are allowed to be configured per VAP. The key holder data is configured per VAP.
• MAC Address — Destination's VAP MAC address which is the R1 Key holder. The PMKR1 is sent in RRB PUSH
message to this AP MAC address. This MAC Address must be unique across all the VAPs.
• R1 Key Holder — The R1 key Holder ID that names the holder of PMK-R1 in the authenticator.
• RRB Key — Key used to encrypt RRM protocol messages.
After you configure the Remote Key Holder Data List settings, you can click Restore to restore the old settings,
Note
or click Apply to save the settings. Click Cancel to go back before Fast Roaming page.
Click Apply after copying or deleting a profile.
Caution Clicking Export for selected profile/s will export only those profiles. Clicking Export with no profiles selected
will Export all the profiles.
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
Configuring Remote Key Holder List Profiles
71