Cisco WAP581 Administration Manual page 77

Wireless Bridge
WGB Port
VLAN ID
The Infrastructure Client Interface will be associated with the upstream WAP device with the configured
Note
credentials. The WAP device may obtain its IP address from a DHCP server on the upstream link. Alternatively,
you can assign a static IP address.
SSID Broadcast
Client Filter
If you choose Local or RADIUS, see
Note
list.
Step 5 Click Apply. The associated downstream clients now have connectivity to the upstream network.
Uplink
Specifies the VLAN associated with the BSS.
Specifies if the broadcast of the SSID is
available, enabled or disabled.
Not Applicable (N/A)
Client Filter, on page 56
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
WorkGroup Bridge
Downlink
Configure the Access Point Interface with the
same VLAN ID as advertised on the
Infrastructure Client Interface.
Check if you want the downstream SSID to be
broadcast. SSID Broadcast is enabled by
default.
Choose one of the following options:
• Disabled—The set of clients in the APs
BSS that can access the upstream network
is not restricted to the clients specified in
a MAC address list.
• Local—The set of clients in the APs BSS
that can access the upstream network is
restricted to the clients specified in a
locally defined MAC address list.
• RADIUS—The set of clients in the APs
BSS that can access the upstream network
is restricted to the clients specified in a
MAC address list on a RADIUS server.
for instructions on creating the Client filter
67