Cisco WAP581 Administration Manual page 76

WorkGroup Bridge
• Work Group Bridge mode currently supports only IPv4 traffic.
• Work Group Bridge mode is not supported across a Single Point Setup.
To configure Work Group Bridge mode:
Step 1 Select Wireless Bridge.
Step 2
Click WorkGroup.
Step 3 Select the WGB Port to which the configuration parameters will be applied.
Step 4 Click edit to configure the following parameters for the Infrastructure Client Interface (Uplink / Downlink):
Table 1: Infrastructure Client Interface (Uplink / Downlink)
WGB Port
Enabled
Radio
SSID
Encryption
Connection Status
Cisco WAP581 Wireless-AC/N Dual Radio Access Point with 2.5GbE LAN Administration Guide
66
• Radio
• IEEE 802.11 Mode
• Channel Bandwidth
• Channel (Auto is not recommended)
See Radio, on page 45 (Basic Settings) for information on configuring these settings.
Uplink
Check the check box to enable the
Infrastructure Client Interface.
Specifies the Radio Id (Radio 1 (2.4 GHz) or
Radio 2 (5GHz)).
Specifies the current SSID of the BSS.
Note There is an arrow next to SSID for
SSID Scanning. This feature is
disabled by default, and is enabled
only if AP Detection is enabled in
Rogue AP Detection (which is also
disabled by default).
The type of security to use for authenticating
as a client station on the upstream WAP
device. It can be one of the following:
• None
• WPA Personal
• WPA Enterprise
Indicates whether the WAP is connected to the
upstream WAP device.
Downlink
Check the check box to enable the
Infrastructure Client Interface.
Specifies the Radio Id (Radio 1 (2.4 GHz) or
Radio 2 (5GHz)).
The SSID for the Access Point Interface cannot
be the same as the Infrastructure Client SSID.
The type of security to use for authenticating.
The options are:
• None
• WPA Personal
Not Applicable (N/A)
Wireless Bridge