Bauer Hypermax Lithium 19115C-B Owner's Manual & Safety Instructions page 8

assembly
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn: Make sure that the trigger is in
the off-position and remove the Battery pack before performing any procedure in this section.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
installing Guard
WarninG! tO prEVEnt SEriOuS inJury
FrOM FLyinG DEBriS anD piEcES OF
triMMinG LinE: install the guard
only in the orientation shown.
1. Align the Guard with the bottom of the
Trimmer Head as shown in Figure A. Slide
the tabs on the Guard into the slots on
the bottom of the Trimmer Head.
2. Turn the Trimmer upside down and secure
the Guard to the Trimmer Head using the
Attachment Screw provided. Do not overtighten.
installing Wheel assembly
The Wheel Assembly may be installed in one of three optional positions to use the tool
for forward and reverse trimming, side to side trimming, or edging procedures.
Edger Wheel Setup
1. Slide the Wheel Assembly down
onto the Metal Plate located on the
side of the Trimmer Head. Make
sure the Wheel Assembly locks onto
the Plate – i t will click into place
when properly installed.
2. Remove the Wheel Assembly
by pushing in on the Tab and
pulling up on the Wheels.
Page 8
attachment
Wheel
assembly
For technical questions, please call 1-888-866-5797.
Screw
View from
underside
Figure a
tab
Metal
plate
Figure B
Guard
Item 64995