Advertisement
Quick Links
INSTRUCTION MANUAL / MANUEL D'UTILISATION
FoamWerks
CUTTING BOARD
Can be used with:
WC2001 FoamWerks V-Groove Cutter
WC6001 FoamWerks Straight Cutter
WC6010 FoamWerks Straight/Bevel Cutter
32in (81cm) capacity cutting board with squaring bar and
Support de découpe d'une capacité de 32in (81cm) avec barre d'équerrage
MyBinding.com
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
MODEL W3002
INSTRUCTIONS MANUAL
20 in (51 cm) measuring bar with stop.
Manuel d'instructions
et règle-guide de 20 in (51cm) avec butée
Purchase Date
ID Number (on bottom of board)
Date (on bottom of board)
J1810-DN 05-17
Advertisement
Related Manuals for Logan FoamWerks W3002
Summary of Contents for Logan FoamWerks W3002
- Page 1 INSTRUCTION MANUAL / MANUEL D’UTILISATION MODEL W3002 FoamWerks CUTTING BOARD INSTRUCTIONS MANUAL 32in (81cm) capacity cutting board with squaring bar and 20 in (51 cm) measuring bar with stop. Manuel d’instructions Support de découpe d’une capacité de 32in (81cm) avec barre d’équerrage et règle-guide de 20 in (51cm) avec butée Can be used with: WC2001 FoamWerks V-Groove Cutter...
- Page 2 Warranty Logan Graphic Products, Inc. (“Logan”) warrants the W3002 FW Cutting Board to be free from defects in parts and workmanship for a period of two years from the date of original purchase. Logan warrants that it will either repair or replace, in its sole discretion, any necessary replacement parts found to be defective.
- Page 3 FoamWerks Cutting Board Model W3002 Instruction Manual Assembly Align pins in bottom of measuring bar with holes in board and press to install (Fig. 1). Align squaring bars above slots and press into board slots. Slide longer bar under Guiderail to end of slot (Fig. 1). Measuring Foamboard Set measuring bar stop to dimension of cut.
- Page 4 FoamWerks Cutting Board Model W3002 Instruction Manual Cutting with Model WC 6001 Straight Cutter Fig. 4 Align slot on cutter edge over lip of guiderail (Fig. 4). Cutting with Model WC 6010 Straight/Bevel Cutter Align cutter up against guiderail (Fig. 5). Couper avec le cutter droit Modèle WC 6001 Positionner la rainure du bord du cutter sur le rebord du rail de guidage (Fig.