Advertisement
Quick Links
Advertisement
Related Manuals for Logan Compact Elite 350-1
Summary of Contents for Logan Compact Elite 350-1
- Page 1 Compact Elite 32" Mat Cutter from Logan Graphics - 350-1 Instruction Manual...
- Page 2 INSTRUCTIONS AND OPERATION MANUAL 32in (81cm) mat cutting system with bevel & straight cutters, production stops and 20 in (51 cm) squaring bar. For best results use only authentic Logan blades Uses Logan Replacement Blade #270 CAUTION!! MAT CUTTING BLADES ARE SHARP...
-
Page 3: Identification Of Machine Components
Logan Graphic Products, Inc. (“Logan”) warrants the 350-1 COMPACT ELITE to be free from defects in parts and workmanship for a period of two years from the date of original purchase. Logan warrants that it will either repair or replace, in its sole discretion, any necessary replacement parts found to be defective. - Page 4 Measuring Bar & Stop Installation Align pin in bottom of measuring bar with hole on bar and press to install (Fig. 5). Slide stop onto guide rail (Fig. 5). Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com...
- Page 5 Position the cutter so the start & stop line lines up with the marked line closest to the bottom of the machine (Fig. 11). 2 in Fig. 10 Fig. 9 5.08 cm Fig. 11 Slip Sheet BEVEL MAT CUTTER Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com...
- Page 6 The piece of matboard should now appear to only have one single line across it. If the two lines drawn do not line up with each other, the Mat Guide needs to be re-paralleled. Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com...
- Page 7 If mat guide wedge becomes unscrewed from mat guide, reassemble Screws (2) Mat Guide making sure angle of wedge is aligned correctly (Fig. 19). #602 Slide #603 Wedge Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com...
- Page 8 Fig. 21 Replace mat guide & reparallel mat guide. Loosen three screws one turn Fig. 22 Slide Square against Rail Fig. 23 Adjust Rail to remove gaps Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com...
-
Page 9: Helpful Hints
Cutting a Border Less Than 3/4” - Mark mat (back side) using a pencil and do not use Mat Guide. Blade Life - Use only authentic Logan blades to ensure best results. No two blades last the same amount of time. Size of mats and differences in mat board effect blade life.