Advertisement
DISPLAY Brightness ( via VK-R4 remote control)
The REX DAC display can be dimmed or turned completely OFF by simply pressing the
DISPLAY button on your VK-R4 remote control.
Each press will reduce the brightness of display and LED indicators in steps from full ON
to OFF, and then one press back to full ON. The LED indicators will dim but never turn
completely OFF. With the display OFF, issuing any remote control command that would
normally require a display change (i.e.: source selection) will automatically turn the
display back ON for short period of time.
A blown fuse in the REX DAC is an indication of a serious problem. If a replacement
fuse fails as well, no further attempts should be undertaken. Please contact the factory
for professional service.
The proper fuse ratings are as follows:
For 100-120 VAC Units:
For 200-240 VAC Units:
Factory supplied fuses should be only replaced with the same type and rating.
Servicing
The Balanced Audio Technology REX DAC should require no service other than
changing tubes to maintain its high performance. The six vacuum tubes used in the REX
DAC are quality 6C19s rated for approximately 5000 hours of use. Please direct any
further service inquiries to the factory.
Cleaning
To remove dust, occasionally wipe the front and top surfaces of your REX DAC with a
damp soft cloth. If fingerprints appear, you may use a mild, non-alkaline soap solution.
Do not use abrasive cleaners, as they may damage the fine finish of the unit.
Fuse Protection:
2A 250V Slow Blow
1.0A 250V Slow Blow
Advertisement
