Advertisement
Normally, reseating tubes upon delivery is not required. However, if any tubes
have noticeably drifted out of position due to high transportation stress, it will be
advisable to reseat the tubes. Use the supplied Torx wrench to remove the top cover.
Reseat the tubes in their sockets and reinstall the top cover.
NOTE: Should tube replacement be needed, only properly matched tubes from the
factory should be used.
It is recommended that you provide for at least 6" of free space around the unit for proper
ventilation.
Mount the unit on a hard surface with proper ventilation underneath.
Do not stack the REX DAC on top of other units, nor vice versa.
Connecting the REX DAC to Your System
All connections can be found on the rear panel of the REX DAC.
Inputs:
The REX DAC has six inputs:
These can be selected via either the front panel controls, or the VK-R4 remote control.
Outputs:
Two balanced output connectors are located on the rear panel.
Reseating Tubes
Physical Placement
AES
Coax 1
Coax 2
Toslink 1
Toslink 2
USB
Advertisement
