Safety Information - Bosch TR1500TOR 5 T Installation And Operating Instructions Manual

1

Safety information

This appliance is intended for domestic use and the household
environment only.
• Install and operate the appliance as described in the text and
illustrations. We do not accept liability for damage resulting from
failure to heed these instructions.
• This appliance is intended for use up to an altitude of 2000 m above
sea level.
• The appliance may only be installed and stored in a frost-free room
(due to residual water).
WARNING: Risk of electric shock!
▶ Switch off the mains voltage supply immediately if
a fault occurs.
▶ Immediately shut off the cold water supply to the
appliance should it leak.
• The appliance may only be connected and put into operation by
qualified professional.
• To avoid potential sources of danger, repairs and maintenance
may only be undertaken by a suitably qualified specialist.
• Shut off the water supply before connecting the appliance. Do not
insert the plug into the mains socket.
• Caution!
Fill the appliance with water first, then insert the mains plug,
otherwise the resettable safety temperature limitation will trip.
• Observe the statutory regulations as well as the connection
regulations of the electrical and water utility companies.
• Only connect the appliance to a correctly earthed electrical socket.
Do not use extension cables.
• Disconnect the power supply before opening the appliance.
• The appliance may not be powered via an external switching device
such as a timer switch in order to exclude the danger of an
unintentional reset of the safety temperature limitation in the event
of a fault.
• The connection cable may not make contact with hot components.
This can damage the insulation.
• If the electrical connection cable of this appliance is damaged, it may
only be replaced by one of our authorised customer service
representatives in order to avoid potential sources of danger.
The plug must be removed from the mains before replacement.
• The small water heater is only suitable for use with an open
(unpressurised) and a single tap connection. The warm water
outlet is used for pressure compensation and may only be
connected to suitable fittings (Order No BZ 13051 or BZ 13061
for undersink appliances or BZ 11113 for oversink appliances).
• The tap outlet must always remain free. Do not use perlators
(diffusers) or shower taps.
• This appliance can be used by children aged 8 years and older as
well as by persons with diminished bodily, sensory or mental
perception, or those who lack knowledge or experience, if they are
monitored or have received instruction concerning use and
comprehend the possible dangers that can result. Children may not
play with the appliance. Cleaning and maintenance by the user may
not be performed by unsupervised children.
• Keep children away from the appliance.
• Please monitor children to ensure that they do not play with the
appliance.
• The warm water pipe may be hot. Please inform and instruct children
appropriately.
• Do not use aggressive or abrasive cleaning detergents!
• Do not use a steam cleaner.
TR1500T
Please read this installation and operating instruction manual carefully,
then act accordingly! Store for future reference.
1.1 Installation instructions
Unpacking
• Inspect the new appliance for transport damage!
• Please dispose of the packaging, and if applicable, the old appliance
in an environmentally-friendly manner.
Install the small water heater as shown in the illustrations. Observe
the instructions in the text.
The illustrations can be found in the centre of the instruction manual.
Scope of delivery/Dimensions (Fig. 1)
Water connection (Fig. 2)
▶ Caution!
Do not allow the existing tap mixer to become calcified.
A reduced flow rate will ruin the water heater.
Wall mounting (Fig. 3)
• For mounting without the wall hooks, observe the different
dimensions!
Screwing on the Connection Hoses (Fig. 4)
• Fit the sealing gasket.
• Place the sleeve nuts onto the threads and screw on by hand.
• Tighten the screw fitting.
• Hold the threaded fittings on the water heater with a spanner.
Do not lubricate the thread!
• After the unit has been used to heat water a few times, check the
screws and retighten, if necessary.
Replacement for a damaged threaded fitting is available from customer
service.
First start-up (Fig. 5)
Electrical connection
• Important: Do not insert the plug into the mains socket yet.
• Open the corner valve.
• Completely fill the heater's reservoir with water.
Set the flow on the corner valve.
5 l/min = 1 l in 12 seconds
• Only then insert the plug into the mains socket.
Checking the heating
• Turn the rotary selector switch to "3" (approx. 85 °C).
• Monitor the heating process until the pilot lamp switches off.
• Duration: approx. 12‒18 minutes.
• Check the temperature.
• Caution: If the safety temperature limitation has switched off the
small water heater, unplug the mains plug, open the warm water tap
and allow approx. 4 litres of water to flow. Then plug the mains plug
back in. The appliance is ready again for operation.
Limitation of the water temperature
The temperature of the water leaving the tap for the small water heater
can be mechanically set to stage "1" (approx. 40 °C) or stage "e"
(approx. 60 °C).
Information on temperature limiting can be found in the operating
instructions.
Saving energy
• Turn the rotary selector switch to "e".
• Hand over the installation and operating instructions to the user and
explain how the appliance operates.
Safety information | 7
6 720 876 013 (2017/06)