Detection Range; Setting The System - Dometic WAECO MagicWatch MWE820 Installation And Operating Manual

Detection range

7 Detection range
See fig. d
The detection range of the parking aid is divided into four zones:
 Zone 1 (MWE820, 860)
This zone is the first limit range. Small objects or those with poor reflective
characteristics may not be detected.
 Zone 2
Nearly all objects are displayed in this zone.
 Zone 3
Nearly all objects in this zone are displayed, however objects may only
appear in the sensors' blind spot, or not be detected at all due to their
consistency or small size.
 Stop zone (4)
If there are objects in this zone, the parking aid emits a continuous tone
warning you to stop.
Nearly all objects in this zone are displayed, however objects may only
appear in the sensors' blind spot or not be detected at all due to their
consistency or small size.
Displaying fixed objects, such as a trailer hitch, can be suppressed.
8

Setting the system

There is a button (fig. e 1) on the controller for setting the following param-
eter.
8.1 Setting the sensitivity
➤ Switch on the ignition.
➤ Engage the reverse gear (MWE820, 860).
➤ Press the button for not more than two seconds to set the sensitivity in the
following sequence:
– Low sensitivity: the loudspeaker beeps once
– Medium sensitivity (standard): the loudspeaker beeps twice
– High sensitivity: the loudspeaker beeps three times
Pressing the button repeatedly changes the sensitivity in the above se-
quence.
22
MWE820, 860, 890
EN