Detection Range - Dometic MagicWatch MWE 4004 Installation And Operating Manual

MWE4004
If a siren (accessory) is connected:
➤ Connect the red/grey cable with the negative cable of the siren.
➤ Connect the yellow/blue cable with the signal cable of the siren and the
passenger indicator.
➤ Connect the positive cable of the siren with 12 V/24 V.
➤ Configure the system so that a siren is connected (chapter "Setting the siren or
camera" on page 11).
If a camera (accessory) is connected:
➤ Connect the red/grey cable with the negative cable of the camera.
➤ Connect the positive cable of the camera with 12 V/24 V.
➤ Insulate the red cable of the camera.
➤ Configure the system so that a camera is connected (chapter "Setting the siren or
camera" on page 11).
9

Detection range

See fig. b
The detection range of the blind spot assistant is divided into three zones:
•
Zone 1
This zone is the first limit range. Small objects or those with poor reflective
characteristics may not be detected here.
The green LEDs light up in the LED display.
•
Zone 2
Nearly all objects in this zone are displayed.
The orange LEDs light up in the LED display.
•
Stop zone (3)
If there are objects in this zone, the blind spot assistant emits a continuous tone
warning you to stop.
The red LEDs light up in the LED display.
Virtually all objects are displayed in this zone, but some objects may end up in
the blind spot of the sensors.
EN
Detection range
9