All manuals and user guides at all-guides.com VG 232 AU FOR YOUR SAFETY Page 2 Warnings Page 3 Preface Page 4 1. Important notes Page 5-6 1.1 For your safety Page 5 1.2 Operating for the first time Page 5 1.3 About use...
All manuals and user guides at all-guides.com FOR YOUR SAFETY WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not store articles on or against this appliance Do not use or store flammable materials near this appliance...
All manuals and user guides at all-guides.com Warnings 1. Do not allow the flame to extend beyond the Note: edge of the cooking utensil. This instruction is To avoid jeopardising the electrical safety of the based on safety considerations. appliance, it is forbidden to use high-pressure or steam jet cleaning devices.
All manuals and user guides at all-guides.com Preface Cooking with your new gas cooktop will be even more fun than before. The appliance offers you the following advantages: – Regulation from hot to cold in seconds. – High safety standard thanks to thermal protection elements for all burners.
All manuals and user guides at all-guides.com 1. Important notes 1.1 For your safety You must not operate the appliance if it is Observe caution with oils and fats. They may damaged. overheat and burn easily. Foodstuffs that are prepared in fat and oil (e.g. When connecting electrical appliances in the proxi- French fries) must only be prepared under constant mity of the appliance, make sure that connecting...
The correct sized pots and pans promote even heat distribution and result in a more In the event of malfunctions, contact your efficient use of energy. specialist dealer or your responsible Gaggenau Cooking vessels with curved bottoms, e.g. woks, after-sales service. must not be used.
All manuals and user guides at all-guides.com 2. Structure and operating principle 2.1 Structure 1 High-power burner B 10 MJ (2.8 kW) 2 Normal burner A 6.5 MJ (1.8 kW) 3 Pot support 4 Control knob for the front cooking position 5 Control knob for the rear cooking position Fig.
All manuals and user guides at all-guides.com 2.3 Operating principle The appliance features one-hand operation. That is to say, the ignition is activated when the control knob is pressed briefly. After igniting, keep the control knob pressed for around 5-8 seconds more because the heat sensor that opens the gas valve has to warm up first.
All manuals and user guides at all-guides.com 3. Operation The cooking positions must only be ignited when all burner parts are fitted. Otherwise, malfunctions may occur on the ignition unit. Switching on: – Place a pot or a pan on the corresponding cooking position.
All manuals and user guides at all-guides.com 4. Cleaning and care Please thoroughly clean the appliance before operating it for the first time and after every use. – Wait until the appliance has cooled down. – Remove the pot grid. –...
If the power supply is functioning correctly, but your Fitzroy, Vic. 3065, Tel. (03) 9418 5888. appliance still does not work, please contact your dealer or your local Gaggenau customer service Service Centres in other States: agency. Specify the appliance type (see rating...
All manuals and user guides at all-guides.com 6. Technical data / Settings table Technical data (gas) Technical data (electrical) Burners: Rated consumption 0.8 W Normal burner Voltage 220-240 V Full burning 6.5 MJ (1.8 kW) Low burning < 1.5 MJ (0.41 kW) 50-60 Hz Frequency High-intensity burner...
All manuals and user guides at all-guides.com 7. Assembly instructions 7.1 Important notes Please observe the safety notes and the Warning: important notes (Chapter 1). This appliance shall only be installed by an authorized person. The installer is responsible for perfect functioning of the appliance at its installation location.
All manuals and user guides at all-guides.com 7.2 Connecting the appliance Electrical connection The appliance is connected to the mains (240 V AC) by means of the connecting lead with the earthed plug. It must be plugged into an earthed socket which remains accessible after installation of the appliance.
Page 15
All manuals and user guides at all-guides.com Gas connection The gas connection must be in a location that permits access to the shut-off valve and which, if applicable, is visible after opening the door of the furniture item. By means of the included R 1/2" connection bracket (on the appliance end) with the affiliated washer, the appliance must be connected to a fixed copper.
All manuals and user guides at all-guides.com 7.3 Nozzle replacement Changing over to a different gas type Only authorised specialists are permitted to change over to a different gas type. The nozzles needed for the gas type to be set are available as a conversion kit.
Page 17
All manuals and user guides at all-guides.com Replacing the main nozzle 2 Proceed as follows: – The main nozzle 2 is visible after detaching the burner cover (see Fig. 11). It is unscrewed with a special screw key. – Unscrew the nozzle and insert the new nozzle as specified in the main nozzle table.
All manuals and user guides at all-guides.com 7.4 Installing the appliance Proceed as follows: – Produce the recess for one or several Vario appliance(s) in your worktop. Proceed as indicated on the installation sketch and the dimension table. The dimension table contains details of the space requirement for the trim between the appliances.
Page 19
All manuals and user guides at all-guides.com Operating and assembly instructions VG 232 AU Built-in gas cooktop...