Controls - Kenwood VR-208 Service Manual

www.freeservicemanuals.info
Speaker indicator
MUTE indicator
1
STANDBY STANDBY
POWER
ON / STANDBY ON / STANDBY
POWER
- ON
PHONES
For U.S.A.
and Canada
!
1 POWER key
(For U.S.A. and Canada)
Use to turn the power ON/OFF.
STANDBY indicator
1 ON/STANDBY (
(Except for U.S.A. and Canada)
Use to switch the power ON/STANDBY
when the POWER is turned ON.
STANDBY indicator
2 POWER key
(Except for U.S.A. and Canada)
Use to turn the main power ON/OFF.
3 DOLBY DIGITAL indicator
Lights when the receiver is in the Dolby
Digital mode.
4 CLIP INDICATOR
Lights when the input signal is too large to
be handled by the receiver, and "clipping"
is occurring.
About the STANDBY indicator
This unit has a STANDBY indicator. When the STANDBY indicator is lit, the unit consumes a small amount of power to preserve the memory. This is called
STANDBY mode. This mode also lets you turn the power ON using the remote control.
Frequency display,
Input display,
Preset channel display,
Surround mode display
SP A B
* **** **
MUTE
LFE
Speaker selection indicators
Input channel indicators
Output channel indicators
2 3
DOLBY DIGITAL
AV SURROUND RECEIVER
CLIP INDICATOR
SPEAKERS
A B BASS BOOST MONITOR
– OFF
@ # $
5 DIMMER key
Use to adjust the brightness of the display.
6 P.CALL keys
Use to call up previously registered radio
stations.
) key
7 BAND key
Use to select the broadcast band.
8 AUTO key
Use to select the auto tuning mode.
9 MEMORY key
Use to store radio stations in the preset
memory.
0 VOLUME CONTROL knob
! PHONES jack
Use for headphone listening.
@ SPEAKERS A/B keys
Use to turn the speakers ON/OFF.
# BASS BOOST key
Use to select the maximum adjustment
setting for the low frequency range.
Published in Heiloo, Holland.
KRF-V7510D/V8010D/VR-208/209

CONTROLS

AUTO SOUND indicator
Band indicators
FM
* ;
AM
MHz
kHz
DOWNMIX indicator
Display
4 5
6 7 8
DIMMER P.CALL P.CALL BAND AUTO
MULTI CONTROL
SOURCE
DIRECT INPUT MODE LISTEN MODE SOUND SETUP
% ^ & * ( )
PRO LOGIC
indicator
DIGITAL indicator
S.DIRECT indicator
AUTO indicator
AUTO SOUND DIGITAL AUTO MEMO. indicator
PRO LOGIC S.DIRECT MEMO.
ST. indicator
3 STEREO MONITOR ST.
DOWNMIX
TUNED
TUNED indicator
MONITOR indicator
3 STEREO indicator
STEREO indicator
9 0
VOLUME CONTROL
MEMORY
INPUT SELECTOR
DOWN
¡
$ MONITOR key
% SOURCE DIRECT key
^ INPUT MODE key
Use to switch between the digital and
analog inputs.
& LISTEN MODE key
Use to select the listening mode.
* SOUND key
Use to adjust the sound quality and ambi-
ence effects.
( SETUP key
Use to select the surround sound settings.
) MULTI CONTROL knob
Used to make a variety of settings.
¡ INPUT SELECTOR knob
Use to select the input sources.
12/6/15
UP
3