Table of Contents
Advertisement
ELITE Series Adjustable Portable Backstop Instructions
3. Stand to one side of the unit and lift one of the two handles on the
lower upright (Figure 8-2).
a. If raising the backstop is too strenuous obtain assistance
before attempting to raise.
b. Be sure to maintain control of the uprights while raising. Do
not release handle while raising.
4. Raise backstop to maximum height (the uprights will reach a hard
stop and will be fully vertical).
c. Insert the quick-release pin into the height adjuster.
5. Verify that the top of the rim is 10 feet off the ground.
d. If the rim is not at 10 feet, adjust both feet (be sure to
maintain level side-to-side) until it is.
6. With the backstop still set to 10', verify that the board is still plumb. If
not, adjust according to the procedure in section 6 (step 7).
7. Set both foot stops to the bottom of the openings in the front of the
base and tighten both setscrews using the 3/16" hex wrench (Figure
8-3).
c. You may need to rotate the stops until the setscrews are
facing outward to tighten screws.
d. Tighten setscrews as much as possible without damaging hex
socket.
Figure 8-2: Lift handle on lower upright.
- 14 of 28-
JSL-Inst039
www.jayprosports.com
Advertisement
Table of Contents
