Printek VehiclePro 420 Operator's Manual page 17

DHCP – printer will acquire an IP address from your network DHCP server
Access Point –The printer will broadcast itself as a network connection. The Power LED
will flash off every two seconds while in this mode. The SSID will be the serial number of the
printer.
When connecting to the printer, the passphrase is DASCOM123.
Access Point mode can also be activated outside of the printer web page.
To enter Personal Area Network mode, press and hold the Power and Paper Feed buttons until
the Power and Alert LEDs light. Release both buttons, and the printer will restart in Personal
Area Network mode. To exit Personal Area Network mode, press and hold the Power and Paper
Feed buttons until the Power and Alert LEDs light. Release both buttons, and the printer will
restart in normal Wi-Fi mode.
Current Connection
Previously Connected Networks
Network will be displayed. Select Connect to use one of these access points, or Remove to delete it from
printer.
Available Networks
use one of these access points.
14 www.printek.com
– access points added through Add/Edit.
– access points detected by the printer or added through Add/Edit
– access points detected by the printer will be displayed. Select Add/Connect to
| P: 800.368.4636 | F: 269.925.8539 | E: info@printek.com