Advertisement
Controls - see Fig. 2
Three switches provide a choice of heat settings. A switch is in
the ON position when the side with the markings on (i.e. I, l, or
II) is pushed in.
Switch 1 (I)
Controls the electricity supply to the heater
and the flame effect.
Note: This switch must be in the ON (I)
position for heater to operate with or without
heat.
Switch 2 (I)
Provides 1kW heat output
Switch 3 (II)
Provides 2kW heat output with switch 2 in the
ON positon also.
Thermostat (T) - see Fig.2
In order to maintain a certian room temperature, set the controller
to 'max'. Operate the heater at full power until the required room
temperature ie reached. Turn back the thermostat control knob
until the heater turns off with an audiable 'click'. This temperture
will be kept almost constant by the thermostatic control switching
ON and OFF automatically. Please note that the appliance can
only be switched ON when the thermostat setting is higher than
the room temperature.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to
prevent damage due to overheating. This can happen if the
heat outlet was restricted in any way. The heater will switch
on once the obstruction has been removed and the heater has
cooled. If the cut-out continues to operate intermittently, the
heater should be switched off and a service agent contacted.
WARNING: This heater is not equipped with a device to
control the room temperature. Do not use this heater in small
rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is
provided.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE
POWER SUPPLY BEFORE ATTEMPTING ANY
MAINTENANCE.
Glen Dimplex Australia Pty Ltd.
1340 Ferntree Gully Road,
Scoresby,
VIC 3179,
Australia
www.dimplex.com.au
sales@glendimplex.com.au
Ph: 1300 556 816
Fax: 1800 058 900
Glen Dimplex Australasia Ltd.
35 Harris Road,
East Tamaki,
Auckland
New Zealand
www.dimplex.co.nz
sales@glendimplex.co.nz
Ph: 09 274 8265
Fax: 09 274 8472
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place
of traditional incandescent bulbs. These generate the same
light levels as traditional bulbs, but use a fraction of the energy
consumed.
Recycling
At the end of the electrical products useful life
it should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice in your country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully
with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be used
to clean the outlet grille of the fan heater.
After Sales Service
Please see the separate Warranty leaflet for details of your
Warranty & After Sales Service including contact details.
Should you require after sales information or assistance with this
product, please contact Glen Dimplex Australia on 1300 556 816
(AUS) / 09 274 8265 (NZ) or visit our website at www.dimplex.
com.au (AUS) / www.dimplex.co.nz
(NZ).
Advertisement
