Minimum Clearances; Routine Servicing; Electrical Supply - iQe SIMPLICITY Series User Instructions

luminous bar becomes red. Descriptions
of the errors with the relative alarms and
solutions are given below:
2
– ALL 01
Seek help and advice from a qualified
engineer.
2
2
–
APRE
Circuito
ALL 02
riscaldamento 2
If the system pressure detected is
lower than 0.5 bar, the boiler will stop
and the display will show "ALL 02". To
proceed increase the system pressure
to between 1 and 1.5 bar.
Circuito
riscaldamento 3
Circuito
(impianto tre
riscaldamento 2
zone)
Circuito
riscaldamento 3
– ALL 03 (fig. 27)
(impianto tre
The system pressure detected is
zone)
more than 2.8 bar. Ensure that the
filling loop is turned off and the pipe
detatched. Lower the system pressure
by draining from a radiator.
If problem persists seek help from a
qualified engineer.
Circuito
riscaldamento 2
2
Circuito
riscaldamento 3
(impianto tre
zone)
OPEN
– ALL 04
Seek help and advice from a qualified
engineer.
– ALL 05
Seek help and advice from a qualified
engineer.
– ALL 06 (fig. 27/a)
Press the key
to re-start the boiler.
If the error persists seek help and
advice from a qualified engineer.
8
2
– ALL 07 (fig. 27/b)
– ALL 08
5
– ALL 09
3
Fig. 27
1
2
4
– ALL 10
– ALL 13 (fig. 27/c)
of the controls (2)
5
1
2
2
Fig. 27/a
Press the key of the controls (2)
to re-start the boiler.
If the error persists seek help and
advice from a qualified engineer.
2
Fig. 27/b
Seek help and advice from a qualified
2
5
engineer.
If the boiler detects inadequate system
1
water circulation, the boiler will stop
and display AL 09. Ensure that at least
one radiator is turned on and that all
2
isolation valves are open. If problem
persists it could be due to a blocked
filter within the boiler, seek help and
advice from a qualified engineer.
Seek help and advice from a qualified
engineer.
Press the key of the controls (2)
to re-start the boiler.
If the error persists seek help and
advice from a qualified engineer.
Circuito
riscaldamento 2
3
Circuito
riscaldamento 3
(impianto tre
2
zone)
4
– ALL 14
Seek help and advice from a qualified
engineer.
– ALL 15
Seek help and advice from a qualified
engineer.
Circuito
– From "ALL 20" to "ALL 29"
riscaldamento 2
Request assistance from qualified
technical personnel.
1.5

MINIMUM CLEARANCES

Circuito
The following MINIMUM CLEARANCES
must be available for servicing the
riscaldamento 3
appliance:
(impianto tre
zone)
ABOVE THE
APPLIANCE CASING
AT THE R.H.S.
AT THE L.H.S.
BELOW THE
APPLIANCE CASING
IN FRONT OF THE
2
APPLIANCE
1.6

ROUTINE SERVICING

3
To ensure continued efficient operation
of the appliance, it is recommended that
it is checked and serviced as necessary
at regular intervals. The frequency of
servicing will depend upon the particular
4
installation conditions and usage but in
general once a year should be adequate.
It is the law that any service work must
be carried out by a Gas Safe Register
registered engineer. Ensure that the
service is recorded in the installation
guide use and maintenance section.
1.7

ELECTRICAL SUPPLY

THIS APPLIANCE MUST BE EARTHED.
Circui
riscald
Circui
riscald
(impia
zone)
Fig. 27/c
For servicing
300 mm
15 mm
15 mm
200 mm
500 mm